What is whitening on a card?
Whitening is the white cardboard core showing through where the coloured layer on an edge or corner has worn off. It is permanent.
Article
Nov 9, 2026
Whitening hides on the back of the card. Check the four corners and the two long edges, and learn to tell real whitening from glare.
By the Gradeon Team · Updated

Check six places on the back of your card for whitening: the four corners and the two long edges. They take the most handling, and dark card backs make any wear stand out.
Whitening is the white core of the card showing through where the coloured layer has worn off. The shape of the card is intact; colour is missing, not material. It is the most common defect on cards that were played or stored loose.
Corners take every knock, so start there. Look for a dot of white at the very tip, or "salt": fine white specks along the corner's two edges. Tilt the card under a soft light to see it.
Same check. Compare it with the top-left: wear is often uneven, and one bad corner is enough to cost a grade. In Gradeon, whitening on one corner caps the corners sub-grade at 9.
The bottom corners often wear more, because cards are pulled from decks and binders from the bottom edge.
Finish the corners. Whitening on two or more corners caps corners at 8. If a corner is also rounded or fuzzy, that is a soft corner, which caps corners at 8 on its own, and at 6 on two or more corners.
Run your eye along the whole edge. Long edges collect a white line from shuffling and sliding in and out of sleeves. Whitening along the edge counts against the edges sub-grade, which carries 25% of each side's grade.
Same check on the other side. If the border looks frayed or ragged rather than just white, that is edge wear, a more serious defect.
True whitening shows tan or cream fibres with irregular edges, and it is visible from any angle. Glare is a bright, uniform reflection that follows the light and moves when you tilt the card. That is why Gradeon only reports whitening it is at least 80% confident about, a stricter bar than for any other defect.
Gradeon grades the back exactly as strictly as the front, and the cap rule means a clean front cannot carry a worn back by more than one point. On cards with dark backs, whitening shows even more.
No. Whitening is permanent. Covering it with ink or marker makes the card an altered card, which grading companies refuse to grade.
Run a Full Grade with a detail shot of the worst corner, and Gradeon marks every speck of whitening it finds, front and back.
Whitening is the white cardboard core showing through where the coloured layer on an edge or corner has worn off. It is permanent.
In Gradeon, whitening on one corner caps the corners sub-grade at 9, and on two or more corners at 8.
Many card backs are dark, so white wear on edges and corners stands out more than on a light front.