What is a print line on a Pokémon card?
A print line is a perfectly straight, thin line left by the printing press, usually running the full height or width of the card and often visible only on holo foil.
Article
Nov 9, 2026
Straightness, length, whether the surface is broken and how the line behaves in the light: four ways to tell a scratch from a factory print line on a holo card.
By the Gradeon Team · Updated

To tell a scratch from a print line, check four things: whether the line is perfectly straight, whether it runs the full length of the card, whether it breaks the surface, and how it behaves when you tilt the card.
Both are thin lines on the surface, and both count against the grade. But one is damage and one comes from the factory, and they are rated differently.
A print line comes from the printing press, so it is perfectly straight. A scratch can be straight or curved, and even a straight scratch usually wobbles slightly or tapers at the ends.
Print lines usually run the full height or width of the card, edge to edge, in one direction. Scratches are usually shorter and can point in any direction. A short line in the middle of the artwork is far more likely to be a scratch.
A scratch is cut into the surface: on holo cards it breaks the rainbow pattern, and deep ones remove ink. A print line sits in the print itself and does not break the surface, although it is often visible only on holo foil.
Scratches are usually visible only when the light hits them at a certain angle. Tilt the card slowly under one soft light: a scratch flashes in and out. A print line tends to stay visible as a consistent line in the foil.
Both count. A faint print line rates severity 1–2 and one clearly visible across the artwork rates 3. A short, light scratch rates 1–2, one across the artwork 3, and a scratch deep enough to remove ink 4–5. In Gradeon, any defect of severity 3 or more caps its area at 7, and severity 4 or more caps it at 5. Surface carries 35% of each side's grade, the largest share.
Foil scratches are scratches on the holographic layer, and they count against surface like any scratch. Scuffing, a field of hairline scratches too many to count, is reported as one surface damage box over the area.
The rainbow, cosmos or textured finish of a holo or full-art card is print texture, not a defect. Gradeon is told to ignore it.
For every defect type, read The 11 Defects Every Grader Looks For.
Run a Full Grade with a detail shot of the holo, and each line is tagged SCR or PRL and rated 1–5 on your photo.
A print line is a perfectly straight, thin line left by the printing press, usually running the full height or width of the card and often visible only on holo foil.
Yes. Print lines are factory defects, but grading companies still count them, and so does Gradeon.
A scratch can curve, is usually short and breaks the surface. A print line is perfectly straight and usually runs edge to edge.