Article

Nov 9, 2026

Dents, Creases and Bends: 4 Tests You Can Do With No Tools

A raking-light test, a fold-line test, a flat-table test and a both-sides test: four ways to tell a dent from a crease from a bend, using only a lamp and a table.

By the Gradeon Team · Updated

Gradeon Journal cover for “Dents, Creases and Bends: 4 Tests You Can Do With No Tools”

You can tell a dent, a crease and a bend apart with four tests and no tools: a raking-light test, a fold-line test, a flat-table test and a check of both sides.

The three look similar at first glance, but they are graded very differently. A crease caps a card hard; a dent usually costs little; a light bend may even be restorable.

1. The raking-light test

Hold the card under one soft light and tilt it slowly, so the light skims across the surface. A dent appears as a small shadow or a distortion in the shine: a depression or bump from a fingernail, a stacked object or a binder ring. If nothing breaks the reflection, the surface is flat.

2. The fold-line test

Look closely at any mark you found. A crease has a fold line: broken print or white fibres along the line, or a corner that stays bent or lifted. A dent has no fold line. This is the test that matters most, because a crease is the most expensive defect there is.

3. The flat-table test

Lay the card face up on a flat table, then face down. A card with a light bow rocks slightly or lifts at the edges, with no fold line anywhere. That is a bend, not a crease. Gradeon's restoration advice may flag a slight bow as restorable, because light pressing can sometimes flatten it.

4. The both-sides test

Turn the card over and repeat the raking-light test on the back. A crease usually shows on both sides. The back is graded exactly as strictly as the front, so a mark on the back costs as much as one on the front.

How do they affect the grade?

Defect

Typical severity

Effect in Gradeon

Dent (DNT)

1; wide or deep 2–3

Counts against surface like any defect

Crease (CRS)

2 tiny bend at a tip; 3–4 visible fold; 5 folded edge to edge

Any crease caps surface at 6; two, or one beyond the border, cap it at 4

Light bow

Not a defect type on its own

May be flagged as restorable

Because a crease caps surface at 6 and the cap rule holds each side to its weakest area plus 1.0, a creased card tops out around 7 overall.

Can a crease be fixed?

No. Creases are permanent. Pressing can help a slight bow, not a fold line, and it is legitimate only when it removes nothing and adds nothing.

For all 11 defect types, read The 11 Defects Every Grader Looks For.

Let Gradeon tell them apart

Run a Full Grade and each mark is tagged DNT or CRS, rated 1–5 and drawn on your photo.

Download Gradeon

Frequently asked questions

How do I know if my card is creased?

Look for a fold line with broken print or white fibres, or a corner that stays bent. If there is no fold line and only a shadow or shine distortion, it is more likely a dent.

Can you flatten a bent card?

Light pressing can sometimes flatten a slight bow with no fold line. It cannot fix a crease.

How much does a crease lower a grade?

In Gradeon, any crease caps the surface sub-grade at 6, so a creased card tops out around 7 overall.

Visioned and Crafted by Daniele Dominici & Federico Vietti

© 2026 Gradeon AI. All rights reserved.

Visioned and Crafted by
Daniele Dominici & Federico Vietti

© 2026 Gradeon AI. All rights reserved.